Telect T3 Bedienungsanleitung PDF herunterladen (Seite 13)

Issue A Rev 2 108469 Telect, Inc.

4-1

IN-SERVICE PATCHING

To temporarily connect an NE or DCS circuit to an alternate DCS or NE

circuit on the same or a different DNI-3 panel or DSX without disrupting

service, follow the steps below, using the Twist Lok Jacks (TLJs) on the

front of the appropriate DNI-3 panels and the following additional equip-

ment:

• Four Mini-WECO patch cords (Mini-WECO plug at each end)

• Two 75-ohm Mini-WECO terminating plugs

• One dual bridging office repeater (BOR), or two single BORs

Step Action

1. Using one Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 1, INPUT.

b. Insert the plug of the other end to the monitor TLJ at the first lo-

cation.

2. Using a second Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 1, OUTPUT.

b. Insert the plug of the other end into the IN TLJ at the second lo-

cation.

3. Using a third Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 2, INPUT.

b. Insert the plug of the other end into the monitor TLJ at the sec-

ond location.

4 User Functions

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Telect T3 Bedienungsanleitung Seite 13