Telect T3 Bedienungsanleitung PDF herunterladen (Seite 10)

Installation DNI-3 User Manual

2-4

Telect, Inc. 108469 Issue A Rev 2

7. Starting at the lowest DNI-3 panel and working upward, connect

the DCS OUT cables to the NE-1 OUT termination points on the

rear of the DNI-3 panels.

8. Secure the DCS OUT cables to the wire management tray via the

tie-down slots.

9. Route the NE IN cables to the same side of the network bay as the

DCS IN cables. Tie-wrap the cables in place within the extender

panel cable management brackets.

10. Starting at the lowest DNI-3 panel and working upward, connect

the NE IN cables to the NE-2 IN termination points on the rear of

the DNI-3 panels.

11. Secure the NE IN cables to the tie-down bar.

12. Route the NE OUT cables to the same side of the network bay as

the DCS OUT cables. Tie-wrap the cables in place within the ex-

tender panel cable management brackets.

13. Starting at the lowest DNI-3 panel and working upward, connect

the NE OUT cables to the NE-2 OUT termination points on the rear

of the DNI-3 panels.

14. Secure the NE OUT cables to the tie-down bar.

OUT

Tie-Dow

Bar

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Telect T3 Bedienungsanleitung Seite 10